NETGEAR WAX630 - Page 258

Table 3. Factory default settings (Continued)
Default SettingFeature
2.4 GHz radio: Enabled at 2346
5 GHz L radio: Enabled at 2346
5 GHz H radio: Enabled at 2346
RTS threshold
2.4 GHz radio: 100 millisec.
5 GHz L radio: 100 millisec.
5 GHz H radio: 100 millisec.
Beacon interval
2.4 GHz radio: Disabled (applies in 11ng WiFi mode only)
5 GHz L radio: Nonconfigurable
5 GHz H radio: Nonconfigurable
802.11n 256 QAM
2.4 GHz radio: Enabled
5 GHz L radio: Enabled
5 GHz H radio: Enabled
MU-MIMO
2.4 GHz radio: 2
5 GHz L radio: 2
5 GHz H radio: 2
DTIM interval
2.4 GHz radio: Enabled with a limit of 50 pps
5 GHz L radio: Enabled with a limit of 50 pps
5 GHz H radio: Enabled with a limit of 50 pps
Broadcast and multicast
rate limiting
2.4 GHz radio: Not applicable
5 GHz L radio: Disabled
5 GHz H radio: Disabled
802.11h
DisabledLoad balancing between
radios
DisabledForce sticky clients to
disassociate
DisabledARP proxy
EnabledBroadcast enhancements
None configuredWireless bridge
General security
DisabledURL filtering
None configuredRADIUS servers
2.4 GHz radio: Disabled
5 GHz L radio: Disabled
5 GHz H radio: Disabled
Neighbor AP detection
Eight default ACLs but none configured with MAC addressesMAC ACLs
DisabledL2 security
User Manual258Factory Default Settings and
Technical Specifications
Insight Managed WiFi 6 AX6000 Tri-band Multi-Gig Access Point Model WAX630