Installation Guide for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T
2-8 Basic Setup
For Windows 2000 & 98SE/Me Users Installing a WG311T
Install the WG311T driver and
configuration utility software.
Note: Windows 2000 may require you to be
logged on with administrator rights.
a. Power on your computer, let the
operating system boot up completely,
and log in as needed.
b. Insert the Resource CD for the WG311T
into your CD-ROM drive. The CD main
page shown at the right will load.
c. Click the “Install Driver & Utility” link.
d. Follow the InstallShield Wizard steps,
and click Finish when done.
Note: If you are prompted to restart your
computer, choose instead to shut it
down. This will let you install the
WG311T before restarting. Windows
will find the new hardward and can use
the software you just installed.
WG311T Resource CD
InstallShield Wizard
To Next Page
Loading...
Need help?
General
