Installation Guide for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T
2-4 Basic Setup
Basic Installation Instructions
Use the procedure below that corresponds to the version of Windows you are using.
For Windows XP Users Installing a WG311T
Install the WG311T driver and
configuration utility software.
a. Power on your computer, let the
operating system boot up completely,
and log in as needed.
b. Insert the NETGEAR 108 Mbps Wireless
PCI Adapter WG311T Resource CD into
your CD-ROM drive. The CD main page
shown at the right will load.
c. Click the “Install Driver & Utility” link.
d. Follow the InstallShield Wizard steps,
and click Finish when done to restart
your computer.
WG311T Resource CD
Note: If this page does not automatically appear,
browse the root of the CD and double-click on
autorun.exe to display this page.
InstallShield Wizard
Note: If a Windows XP Certification warning appears,
click Continue Anyway to proceed.
To Next Page
Loading...
Need help?
General
