Installation Guide for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T
3-10 Configuration
How to Configure WEP Encryption Security
Following the steps below to configure WEP Encryption Security.
1. Run the WG311T Configuration Utility.
a. Open the configuration utility by clicking on the WG311T icon in the Windows
system tray.
Figure 3-5: Settings tab page
b. Click on the Settings tab to display the view shown above.
2. Configure the Security settings.
a. Select the Use WEP Encryption check box.
b. Enter the SSID. This is also called the Wireless Network Name.
Note: You will not get a wireless network connection unless the network SSID matches
exactly what is configured in the access point.
To Next Page
Loading...
