NETGEAR WIRELESS-G ROUTER WGR614V10 User Manual

Wireless-G Router WGR614v10 Reference Manual
Fine-Tuning Your Network 5-11
v1.0, February 2010
4. In the Port Triggering Timeout field, enter a value up to 9999 minutes. This value controls
the inactivity timer for the designated inbound ports. The inbound ports close when the
inactivity time expires. This is required because the router cannot be sure when the application
has terminated.
5. Click Add Service.
6. In the Service Name field, type a descriptive service name.
7. In the Service User field, select Any (the default) to allow this service to be used by any
computer on the Internet. Otherwise, select Single address, and enter the IP address of one
computer to restrict the service to a particular computer.
8. Select the service type, either TCP or UDP or both (TCP/UDP). If you are not sure, select
TCP/UDP.
9. In the Triggering Port field, enter the number of the outbound traffic port that will cause the
inbound ports to be opened.
10. Enter the inbound connection port information in the Connection Type, Starting Port, and
Ending Port fields.
11. Click Apply. The service appears in the Port Triggering Portmap table.
Figure 5-4

NETGEAR WIRELESS-G ROUTER WGR614V10 Specifications

General

Brand	NETGEAR
Model	WIRELESS-G ROUTER WGR614V10
Category	Wireless Router
Language	English