NETGEAR RangeMax Dual Band Wireless-N USB Adapter WNDA3100v2 User Manual
2-15
v1.0, June 2009
Setting Up WPA-PSK [TKIP] or WPA2-PSK [AES] Security
To configure WPA-PSK security:
1. Run the WNDA3100v2 Smart Wizard.
a. Make sure that the WNDA3100v2 software is installed and the wireless-N USB adapter is
fully inserted in a USB port in your computer.
b. Use the icon to open the Smart Wizard. The Settings tab displays.
2. Configure the Security settings.
a. In the Profile field, select the profile, or type in a profile name.
b. In the Network Name (SSID) field, and then select the network, or enter the SSID.
c. In the Security section, select WPA-PSK [TKIP] or WPA2-PSK [AES], and enter the
passphrase.
For more about WPA2-PSK, see the link to “Wireless Communications:” in Appendix B.
3. Save your settings in a profile.
a. Click the Save Profile button. All the configuration settings are saved in this profile.
Note: You will not get a wireless network connection unless the network SSID
matches exactly what is configured in the access point.
Figure 2-13
To Next Page
Loading...
