NETGEAR WNR2000v2 User Manual

NETGEAR Wireless-N 300 Router WNR2000v2 User Manual
Customizing Your Network Settings 4-12
v1.0, January 2010
6. In the Destination IP Address field, enter the IP address of the final destination.
7. In the IP Subnet Mask field, enter the IP subnet mask for this destination.
If the destination is a single host, enter 255.255.255.255.
8. In the Gateway IP Address field, enter the gateway IP address, which must be a router on the
same LAN segment as the WNR2000v2 router.
9. In the Metric field, enter a number between 1 and 15 as the metric value.
This represents the number of routers between your network and the destination. Usually, a
setting of 2 or 3 works, but if this is a direct connection, set it to 1.
10. Click Apply to have the static route entered into the table.
Wireless Repeating Function
You can view or change wireless repeater settings for the wireless router. From the main menu of
the browser interface, under Advanced, click Wireless Repeating Function to display the
Wireless Repeating Function screen.
Figure 4-7

NETGEAR WNR2000v2 Specifications

General

Brand	NETGEAR
Model	WNR2000v2
Category	Network Router
Language	English