19
4.5 Restoring factory defaults
This operation deletes all user settings and restores the configuration to the factory defaults. It is
useful when the device is in an unknown state or does not behave as described in this manual.
Procedure:
1. Turn off (unplug) the PowerBOX from power grid.
2. Press and hold the button.
3. Connect the device plug to the power grid (button is still pushed) and wait at least 10 until the
yellow LED on the RJ45 jack flashes 3 times, release the button.
4. The device reverts to the factory settings.
Forgotten password
The reset to factory defaults is also used when the password has been forgotten. After
restoring the factory defaults, the username and password to access the PowerBOX will
be “admin” / “admin”.
4.6 Controlling the output manually
The outputs can be switched on/off (toggled) by pressing the button quickly 3 times in a row.
1. Press the “DEFAULT” button three times fast to toggle the outputs.
Note: If at least one output is ON the “toggle” by button change all outputs to OFF. If all outputs
are OFF the “toggle” change all to ON.
To Next Page
Loading...