Netio PowerBOX 3PF - M2 M API Protocol - JSON over HTTP

33
5.2.2 M2M API Protocol – JSON over HTTP
Figure 19 – JSON API protocol configuration
Enable JSON API
Enables M2M JSON API functions in the system.
Port
Read-only value. Indicates the port where the device currently listens
for M2M JSON API commands. This port is the same for all http based
M2M API protocols and web administration and can be changed in
Settings / System (chapter System).
Enable READ-ONLY
Enables Read-Only access via M2M JSON API for monitoring. You may
also fill in the username and password for this mode.
Enable READ-WRITE
Enables Read/Write access for monitoring and output control. You may
also fill in the username and password for this mode.
Username
Username for the respective access mode (Read-Only/ReadWrite). Note
– this is unrelated to the username for accessing the NETIO device web
administration. When left empty, the protocol will not require any
authentication.
Password
Password for the corresponding username (Read-Only/ReadWrite).
Save Changes
Saves the changes.