Netio PowerBOX 3PF - M2 M API Protocol - URL API (Http Get)

37
5.2.3 M2M API Protocol – URL API (http get)
Figure 21 –URL API protocol configuration
Enable URL API
Enables M2M URL API functions in the system.
Port
Read-only value. Indicates the port where the device currently listens
for M2M URL API commands. This port is the same for all http based M2M
API protocols and web administration and can be changed in Settings /
System (chapter System).
Enable READ-WRITE
Enables READ-WRITE access.
Password
Password to authenticate HTTP GET communication (pass attribute in
the request).
Save Changes
Saves the changes.
URL API protocol does not contain energy measurement data and counters. URL API also do not
provide information about current output states. This protocol is recommended to Outputs control
only.
When the URL API is enabled, other M2M protocols are disabled. After clicking Save changes, you
will be asked to confirm the deactivation of the other protocols.