Netio PowerBOX 3PF - M2 M API Protocol - XML over HTTP

28
5.2.1 M2M API Protocol – XML over HTTP
Figure 17 – XML API protocol configuration
Enable XML API
Enables M2M XML API functions in the system.
Port
Read-only value. Indicates the port where the device currently listens
for M2M XML API commands. This port is the same for all http based M2M
API protocols and web administration and can be changed in Settings /
System (chapter System).
Enable READ-ONLY
Enables Read-Only access via M2M XML API for monitoring. You may also
fill in the username and password for this mode.
Enable READ-WRITE
Enables Read/Write access for monitoring (reading values) and writing
(output control). You may also fill in the username and password for this
mode.
Username
Username for the respective access mode (Read-Only/ReadWrite). Note
– this is unrelated to the username for accessing the NETIO 4x web
administration interface. When left empty, the protocol will not require
any authentication.
Password
Password for the corresponding username (Read-Only/ReadWrite).