Netio PowerBOX 3PF - M2 M API Protocol - Modbus;Tcp

45
5.2.5 M2M API Protocol – Modbus/TCP
Figure 23 – Modbus/TCP protocol configuration
Enable Modbus/TCP
Enables M2M Modbus/TCP functions in the system.
Port
Specific port for Modbus/TCP only, range 1 – 65535. The device do NOT
alerts you if you specify a port number that is already occupied.
Last access IP
Read-only value indicating the IP address from which the last
Modbus/TCP command was received. The “Refresh” button updates this
value.
Enable IP filter
To improve security, the IP filter can be used to specify a range of IP
addresses from which Modbus/TCP commands are accepted. Commands
from addresses outside of this range will be ignored.
Save Changes
Saves the changes.
Note: Measurement available only for PowerBOX 4Kx.
When the Modbus/TCP is enabled, other M2M protocols are disabled. After clicking Save changes,
you will be asked to confirm the deactivation of the other protocols.