Quick Setup Guide
Get Started: Connect scanner with your device via USB cable. If you use US
keyboard, it's plug and play. If you use other type of keyboard , please refer to
"keyboard language" to set the keyboard language before use it.
Barcode Programming
Netum barcode scanners are factory programmed for the most common
terminal and communications settings. If you need to change these settings,
programming is accomplished by scanning the bar codes in this guide. An
asterisk (*) next to an option indicates the default setting.
Firmware Version
Scan below barcode to check scanner's �irmware version.
Factory Restore
Scan below barcode to revert all settings to factory defaults.
Keyboard Languages
Follow below instructions to con�igure the keyboard language before you use it.
For example If you use French Keyboard, scan command barcode of “French
keyboard ”. If you use a US keyboard you can ignore this step.
0A
0B
(1)
To Next Page
Loading...
