Neuropace RNS System - Neuro Pace Cortical Strip Lead; Neuro Pace Depth Lead

Responsive Neurostimulator System 22
RNS
®
System User Manual
Lead Strain Relief (Model LSR-01)
The lead strain relief supports the proximal end(s) of the lead(s) at their exit from the neurostimulator
connector cover, protecting the lead from stress near the connector.
Magnet (Model M-01)
The magnet is a doughnut-shaped magnet which, when placed over the implanted RNS
®
Neurostimulator, suppresses therapy as long as the magnet is in position and, if the neurostimulator
is programmed to do so, triggers an electrocorticogram (ECoG) storage.
Torque Driver (Model TD-01)
The torque driver is used to tighten the screw that secures the connector cover to the neurostimulator
and to tighten the ferrule clamp that secures the neurostimulator to the ferrule.
N
EUROPACE
®
CORTICAL STRIP LEAD
The NeuroPace
®
Cortical Strip Lead is intended for subdural implant to provide an interface through
which electrical activity of the brain can be monitored and electrical stimulation can be delivered.
Cortical Strip Leads
NeuroPace
®
Cortical Strip Leads are available in the following lengths:
15 centimeters (model CL-315-10)
25 centimeters (model CL-325-10)
35 centimeters (model CL-335-10)
There are four electrodes spaced 10 millimeters apart from each other. All four electrodes can be
configured for sensing, detection, and stimulation.
WARNING: COMPATIBILITY WITH SIMILAR IMPLANTABLE PRODUCTS
The NeuroPace
®
RNS
®
Neurostimulator, NeuroPace
®
Cortical Strip Lead, and
NeuroPace
®
Depth Lead are not compatible with non-NeuroPace leads and / or pulse
generators. Incompatible configurations may cause damage to the products and may
result in unsafe current densities delivered to the patient.
N
EUROPACE
®
DEPTH LEAD
The NeuroPace
®
Depth Lead is intended for implant into the brain to provide an interface through
which electrical activity of the brain can be monitored and electrical stimulation can be delivered.
Depth Leads
NeuroPace
®
Depth Leads are available in the following configurations:
30 centimeter length, 10 millimeter electrode spacing (model DL-330-10)
30 centimeter length, 3.5 millimeter electrode spacing (model DL-330-3.5)
44 centimeter length, 10 millimeter electrode spacing (model DL-344-10)
44 centimeter length, 3.5 millimeter electrode spacing (model DL-344-3.5)
All four electrodes can be configured for sensing, detection, and stimulation.