25
Appendix (
Segment Timer
)
To Shorten the Segment List:
1. Press
SET ---
then
OPTIONS.
2. Answer questions as desired
3. When the control asks ---
EDIT SEGMENT TIMER?
--- (Press
Yes
).
[ EDIT01 12:34 Y/N ]
(The control displays the word “EDIT”, the segment number “01”, and
the segment time “12:34”, and the prompt “Y/N”) the control is asking if
you want to edit the segment. --- (press
No
).
[ EDIT02 23:00 Y/N ]
(Each time you press No, the next segment in the list is displayed).
[ EDIT03 05:00 Y/N ]
(When the control is displaying the first segment past where the list
should end --- (press
Yes
)***.
4.
[ SEG 03 MM:SS ]
(Press
0
)
(0 minutes and 0 seconds).
5.
[ SEG 03 0M:SS ]
(Press
Yes
). NOTE: A segment set to zero time marks the end of the segment
list and will cause it to start over with segment 01. All subsequent segments are cleared.
6.
ADD ANOTHER SEGMENT?
--- (Press
No
). (Exits the edit mode).
7. Answer the remaining questions as desired and return to normal operating mode.
***NOTE: You can only mark a new end of list. You cannot randomly remove segments.
To Change the Length of a Segment:
1. Press
SET ---
then
OPTIONS.
2. Answer questions as desired
3. When the control asks ---
EDIT SEGMENT TIMER?
--- (Press
Yes
).
[ EDIT01 12:34 Y/N ]
(The control displays the word “EDIT”, the segment number “01”, and
the segment time “12:34”, and the prompt “Y/N”) the control is asking if
you want to edit the segment. --- (Press
No
).
[ EDIT02 23:00 Y/N ]
(Each time you press No, the next segment in the list is displayed).
[ EDIT03 05:00 Y/N ]
(When the control is displaying the segment you want to change ---
(Press
Yes
).
4.
[ SEG 03 MM:SS ]
(Press
0,
press
5,
press
3
)
(5 minutes ands 30 seconds).
5.
[ SEG 03 05:3S ]
(Press
Yes
to accept and move to the next segment).
6.
[ EDIT04 15:00 Y/N ]
(You may now choose whether or not to edit this segment).
7.
ADD ANOTHER SEGMENT?
--- (Press
No
). (Exits the edit mode).
8. Answer the remaining questions as desired and return to normal operating mode.
.
To Next Page
Loading...
