16
V
ext
When V
ext
sync is selected, the user may drive the chopper motor directly with
a DC input voltage. 0 to -10 V DC corresponds to 0 to 100% of the highest
motor speed.
MOTOR
Use the supplied cable to connect the chopping head to the chopper controller
at the back panel.
IEEE-488
The instrument may be programmed remotely via IEEE-488. Use a standard
cable to connect the instrument to the host computer system.
Power entry module
The AC power is connected at the power entry module on the back panel. The
line voltage and power cord have been chosen at the factory to match the
country of consignment. If it is necessary to change the mains voltage, con-
sult the section on AC Operating Voltages (Page 43).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...