Newco FKP-4T - Factory Programming Access

17
Fig 2: Factory
Programming
Settings
Exit
Exits the
Factory
Programming
Menu
Machine Options
See Machine
Options Menu
below
Flowmeter Test
Flow Meter
Diagnostic Test
Drain Water Lines
Remove Excess
Water in lines prior
to Moving machine
Factory Reset
Resets Machine to
Factory Defaults
Call for Service
Allows entry of a
Call for Service
Phone Number
This menu is accessed by holding
the lower right corner of the
touchscreen when cycling power
to the machine. Continue to hold
until the Factory Programming
Menu Appears
Machine Cycle
Count
Non-resettable
Cycle Count Display