Need help?Do you have a question about the Newland HR200 and is the answer not in the manual?
Step-by-step guide on how to connect the HR200 using a USB cable.
Instructions for connecting the HR200 scanner via an RS232 cable.
Guide for establishing a connection using the PS/2 interface for the HR200.
Details the process of reading barcodes with the HR200, including aiming and successful reads.
Explains how to program the engine using special barcodes.
How to enable and disable the code programming function for the HR200.
Resets parameters to factory defaults or saves user-defined settings.
Details serial port settings like baud rate, parity, data bits, and stop bits.
Details the USB HID-KBW protocol for keyboard emulation.
Information on using the HID-POS interface for POS applications.
Configuration settings for the Code 128 barcode symbology.
Settings specific to the EAN-8 barcode symbology.
Configuration options for the EAN-13 barcode symbology.
Settings for the UPC-E barcode symbology, including addenda and check digits.
Configuration options for the UPC-A barcode symbology.
Settings for the Interleaved 2 of 5 barcode symbology.
Configuration options for the Matrix 2 of 5 barcode symbology.
Settings for the Code 39 barcode symbology, including start/stop and ASCII.
Configuration options for the Codabar barcode symbology.
Settings for the Code 93 barcode symbology, including message length and check digit.
Configuration options for the UCC/EAN-128 barcode symbology.
Settings for adding user-defined prefixes before or after barcode data.
Settings for appending user-defined suffixes after barcode data.
A comprehensive list of all parameters and their factory default settings.
General| Brand | Newland |
|---|---|
| Model | HR200 |
| Category | Barcode Reader |
| Language | English |
To Next Page