Newlong NP-7A - 4. START OPERATION; Initial Machine Startup; Running and Thread Cutting

4.START
Beforestarting,makesurethatthesupplyvoltageaccords
withthespecificationofthemotor.
Holdthemachineinyourrighthandandplaceyourindex
fingerontheswitchbuttononthehandle.(Fig.6)
Holdthebaginyourleftlightlyandinsertthebagmouth
betweenFeedDogandPresserFoot.(Fig.7)
Runthemachinewhilekeepingthebagstraight.
Neverpullorpullbackthebag.
Afterclosing,thethreadiscutbythebuilt-innibblertype
cutter.
Whencuttingthethread,leaveatleast3cmlongextended
tailtopreventtheunwillinglooseningoftheseam.(Fig.9)
Runthemachinewithemptybagsandmakesureyouarewell
versedinitsoperationbeforeenteringintoactualoperation.
4
Fig.7Fig.6
Fig.8 Fig.9