ESP302 Controller Start-Up Manual
21 A1270B1 - EDH0411En1021 – 02/20
Setting HOST dynamic IP address through the website
• Connect to REMOTE plug of the ESP302 as described in section 3.7.1: “Direct
Connection to the ESP302 Controller”.
• Connect the Ethernet cable to the HOST connector of the ESP302 controller and to
your network.
• Get to Controller → IP management web page
• Select dynamic IP as shown below:
• Click the “SAVE CONFIGURATION” button and the following screen appears:
• Click "OK" and reboot the controller by clicking REBOOT.
A pop-up window appears showing “REBOOT IN PROGRESS”. When the boot
sequence is complete, the user is redirected to the login page. The time to reboot is
about 50 seconds.
To Next Page
Loading...
