ESP302 Controller Start-Up Manual
A1270B1 - EDH0411En1021 – 02/20 18
3.7.2 Connecting the ESP302 to a Corporate Network Using Static IP Configuration
Setting HOST static IP address through the front panel
• Go to "Setting/Ethernet" tab.
• Tick "static IP".
• Enter your IP address, Netmask and Gateway.
• Press "Set" to apply changes.
When complete, the new IP address is displayed on the top of the screen.
CAUTION
The Static IP address, the Netmask value and the Gateway IP
address must be provided by your Network Administrator to avoid
network conflicts!
NOTE
To avoid conflict with the REMOTE Ethernet plug, the IP address must be
different from 192.168.254.
NOTE
For the majority of Networks, the setting above for the Netmask value will work.
However, for larger networks (200 computers or more), the Netmask value address
must be verified with the IT department. In most cases and for larger networks,
the Netmask value is set to 255.255.0.0.
To Next Page
Loading...
