ESP302 Controller Start-Up Manual
A1270B1 - EDH0411En1021 – 02/20 36
7.0 Appendix C: Power Inhibit Connector
7.1 Description
Inhibit in ESP302 is a female BNC Connector intended for wiring a remote STOP ALL
switch. (If not used, the BNC plug must remain in place to allow operation)
The BNC pin is connected to ESP302 inhibit and BNC outer shell is connected to GND.
For normal operation of the ESP302, the Inhibit must be connected to GND in order to
work. When inhibit is open the motor power supply is switched OFF
Figure 20: Inhibition connector.
To Next Page
Loading...
