Newport OPHIR Photonics Spiricon Pyrocam IV - Page 26

Pyrocam IV Operator’s Manual Document No. 50337-001 Rev F 2/21/2017 Page 26
The Pyrocam has been tested with the following examples:
 Grab and Attributes Setup.vi
 Grab and Basic Attributes.vi
 Grab and Detect Skipped Buffers.vi
 Grab and Reconfigure.vi
 Grab and Select Interface.vi
 Grab.vi
 Sequence.vi
 Snap.vi
 Low-Level Grab Async.vi
 Low-Level Grab Raw Data.vi
 Low-Level Grab.vi
 Low-Level SDequence.vi
 Low-Level Snap.vi
The following examples do not work “as-is” with the Pyrocam:
 Grab (177x Smart Camera).vi
 “NI-IMAQdx (Hex 0xBFF6900F) Attribute not supported by the camera.”
 Grab and Bayer Decoding.vi
 Times out after changing any of the Red, Green, or Blue sliders
 Grab and Scalable Format.vi
 “NI-IMAQdx (Hex 0xBFF6900F) Attribute not supported by the camera.”