Pyrocam IV Operator’s Manual Document No. 50337-001 Rev F 2/21/2017 Page 42
APPENDIX F – TABLE OF FEATURES
The Pyrocam contains hundreds of features. All of the features, except for those identified
as read-only, can be changed by any program that communicates with a GenICam
compliant camera. However, only a very small subset of Pyrocam features should be
changed by the normal user. Below is a list of the only features that should be changed
and read-only features that could be useful. We can provide support only for the features
in this list. Changing any other feature will cause the Pyrocam to misbehave and may
cause it to stop working.
Value or
Range or
Default
Name of the manufacturer of
the device.
Version of the device
interface.
(this is not the firmware
version)
Device identifier (serial
number)
Resets the device to its power
up state.
Effective width of the sensor
in pixels.
Effective height of the sensor
in pixels.
Maximum width (in pixels) of
the image.
Maximum height (in pixels) of
the image.
Width of the Image provided
by the device (in pixels).
Height of the Image provided
by the device (in pixels).
Format of the pixel to use for
acquisition.
Sets the acquisition mode of
the device
Starts the acquisition of the
device
Stops the acquisition of the
device
Sets the Exposure time (in
microseconds)
To Next Page
Loading...
Need help?
General
