Pyrocam IV Operator’s Manual Document No. 50337-001 Rev F 2/21/2017 Page 9
2.1.2.2 Power
The Pyrocam is provided with a 12Vdc/24W AC to DC universal power supply. The
power connection is made by plugging the output power cable into the camera and
connecting the power supply to a proper AC source.
2.1.2.3 Trigger
For pulsed operations, connect the trigger source to this SMA connector. An SMA to
BNC adapter cable is supplied. A TTL trigger pulse can trigger the Pyrocam. The trigger
is rising edge sensitive.
Figure 2.1: Typical Cabling Diagram
2.1.3 Driver Installation
The eBus Universal Pro driver required to run the Pyrocam is included with BeamGage.
The Spiricon Camera Driver Manager is launched at the end of the BeamGage
installation. Select the Pyrocam IV then click the Install button. You can close the
Spiricon Camera Driver Manager when finished. BeamGage will now automatically
connect to the Pyrocam when powered and connected to the computer.
For more information, consult the Getting Started with Gig-E Camera in BeamGage User
Notes included with the Pyrocam.
To Next Page
Loading...
