Newtec MDM6000 - Set Date & Time

EUM/OPS/MAN/14/780549
v1F e-signed, 25 July 2017
Newtec MDM6000 DVB-S2 Receiver EUMETCast Setup Guide
Page 7 of 20
 Select Mgmt Itf from the corresponding soft button.
 Navigate to IP Address.
 Press OK (to unfold the branch).
 Navigate to Mgmt1.
 Press OK.
 Navigate to IP Address/prefix and press OK.
 Use the Soft Buttons to enter a new IP Address/prefix.
 Press OK to confirm the setting.
 Now connect the Ethernet cable to Mgmt1 on the back panel.
 Now you can access the device from a management PC.
To save this configuration:
 Use the Soft Button Arrow and navigate completely to the right of the root menu pane
and select Actions.
 Navigate to Device Configuration Save and press OK.
 Select the configuration file name and Press OK to save the configuration.
Note : The only way to shut down the device is to disconnect the power cable from the power
connector. Therefore make sure that the power cable is accessible and not obstructed when
the device is operational
3.3 Set Date & Time
This section explains how to set the Date and time.
 Select Device from the corresponding soft button.
 Navigate to Date and Time.
 Press OK (to unfold the branch).
 Navigate to Date or Time and press OK.
 Use the navigation down button to display numerical values.
 Use the Soft Buttons to enter a new Date or Time.
 Press OK to confirm the settings.