Need help?Do you have a question about the Newtec MDM3300 and is the answer not in the manual?
Advises users to read safety precautions found on the provided CD-ROM.
Guides users on how to access the modem's web interface via a browser.
Provides an overview of the modem's status, including interface statistics.
Guides the user through the step-by-step terminal installation process.
Explains how to select the correct outdoor unit type for the modem.
Guides the user to select the appropriate spot beam identifier for their location.
Describes the methods for pointing the satellite antenna, manual and automatic.
Details the manual antenna pointing procedure using the Point&Play tool.
Explains the automatic antenna pointing method using an Antenna Control Unit (ACU).
Describes the automatic software update process for the modem.
Guides the user through validating the terminal installation, including disclaimer and location entry.
Explains the disclaimer acceptance step during validation.
Details how to enter the terminal's geographical location by address or coordinates.
Describes the final validation process and certification results.
Covers the configuration settings for the modem's interfaces.
Describes the Ethernet interface and its configuration parameters.
Describes the interface settings between the terminal and the satellite.
Explains how to enable automatic pointing using an Antenna Control Unit (ACU).
Covers diagnostic tools for checking the modem's status and performance.
Details various tests that can be run to check the terminal's functioning status.
Guides on selecting and checking different satellite beams in expert mode.
Explains how to define and add new beam settings in expert mode.
Explains the parameters for setting up an installation carrier for testing.
Details how to control and monitor the installation carrier test.
To Next Page
General
