PPA5xx/15xx user manual
i
IMPORTANT SAFETY INSTRUCTIONS
This equipment is designed to comply with BSEN 61010-1
(2001) (Safety requirements for electrical equipment for
measurement, control, and laboratory use) – observe the
following precautions:
This instrument is to be connected and operated only by qualified
personnel.
This appliance must be earthed. Ensure that the instrument is
powered from a properly grounded supply before connecting to
any live inputs.
Ensure that the supply voltage agrees with the rating of the
instrument printed on the back panel before connecting the
mains cord to the supply.
The inputs are rated at 1kV rms or dc cat II; 600V rms or dc cat
III. Do not exceed the rated input.
Ensure that the voltage and current inputs are connected
correctly before energising the load to be measured.
Keep the ventilation slots in the top and sides of the cover free
from obstruction.
Do not operate or store under conditions where condensation
may occur or where conducting debris may enter the case. Do not
use in a wet environment.
Ensure that the handle is correctly fitted before using it to lift or
to carry the instrument.
There are no user serviceable parts inside the instrument – do
not attempt to open the instrument, refer service to the
manufacturer or his appointed agent.
To Next Page
Loading...
Need help?
General
