PPA5xx/15xx user manual
6-3
6.1 User data
The PPA5xx/15xx can be personalised by entering up to 3
lines of user data as text (see section on text entry).
User data is displayed every time that the instrument is
switched on to identify the instrument. The entered text
may also be read over the communications to identify the
instrument (see USER?).
A typical arrangement of the user data might be:
line 1 company name
line 2 department or individual name
line 3 unique identifying number (eg. asset number)
Any user data may be entered as required, as the lines are
treated purely as text and are not interpreted by the
PPA5xx/15xx at all.
After changing the user data, execute ‘store’ to save the
data in non-volatile memory.
For use in a production environment, the PPA5xx/15xx
supports two modes of operation, supervisor and user.
When supervisor mode is disabled, the stored programs
can only be recalled, not changed. The PPA5xx/15xx saves
the mode of operation with the user data so that it may be
configured to power up in either mode as required.
To Next Page
Loading...
Need help?
General
