Step 4
Your account in the Nexxt Home app has been created
successfully.
III. Router installation
Follow the steps below to install the device:
1. Dene where you are going to place the device.
Remember that you should place it no more than
5 feet from the modem.
2. Connect the modem to the WAN port of the Bolt AX1800
using the Ethernet cable contained in the packaging.
3. Insert one end of the cable/power adapter into the
corresponding port on the back panel. Next, plug the
other end into a wall outlet.
4. Wait about a minute for the connection LED to ash blue.
Note: If your connection is wired, connect the router to
your computer with an Ethernet cable.
To Next Page
Loading...
