Not all accessories are available on all markets.
ACCESSORY CARD AXC 50
An accessory board is required if, for example, a ground water
pump or external circulation pump is to be connected to F1355
at the same time as the indication of common alarm is activ-
ated.
Part no. 067 193
ACTIVE/PASSIVE COOLING IN 2-PIPE SYSTEM
HPAC 45
Combine F1355 with HPAC 45 for passive or active cooling.
Intended for heat pumps with outputs 24 – 60 kW.
Part no. 067 446
ACTIVE/PASSIVE COOLING IN 4-PIPE SYSTEM
ACS 45
Part no 067 195
AUXILIARY RELAY HR 10
Auxiliary relay HR 10 is used to control external 1 to 3 phase
loads such as oil burners, immersion heaters and pumps.
Part no 067 309
BUFFER VESSEL UKV
UKV 300
Part no. 080 301
UKV 200
Part no. 080 300
UKV 500
Part no. 080 302
COMMUNICATIONS MODULE MODBUS 40
MODBUS 40 enables F1355 to be controlled and monitored
using a DUC (computer sub-centre) in the building. Commu-
nication is then performed using MODBUS-RTU.
Part no 067 144
COMMUNICATIONS MODULE SMS 40
When there is no internet connection, you can use the access-
ory SMS 40 to control F1355 via SMS.
Part no 067 073
CONNECTION BOX K11
Connection box with thermostat and overheating protection.
(When connecting Immersion heater IU)
Part no. 018 893
CURRENT SENSOR CMS 10-200
Current sensor with working area 0-200 A.
Part no. 067 596
DOCKING KIT SOLAR 42
Part no 067 153
ENERGY MEASUREMENT KIT EMK 500 (ONE
PER COOLING MODULE)
This accessory is installed externally and used to measure
the amount of energy that is supplied for the pool, hot water,
heating and cooling in the building.
Cu pipe Ø28.
Part no. 067 178
EXHAUST AIR MODULE NIBE FLM
NIBE FLM is an exhaust air module designed to combine re-
covery of mechanical exhaust air with ground source heating.
Bracket BAU 10
Part no. 067 526
NIBE FLM
Part no. 067 011
37Chapter 7 | AccessoriesNIBE F1355
7 Accessories
To Next Page
Loading...
