Nibe F730 - Page 33

Caution
An increase in the room temperature can be slowed by the thermostats
for the radiators or under floor heating. Therefore, open the thermostats
fully, except in those rooms where a cooler temperature is required,
e.g. bedrooms.
If the exhaust air temperature falls below 6 °C the compressor is
blocked and electric additional heat is permitted. Heat is not recovered
from the exhaust air when the compressor is blocked.
TIP
Wait 24 hours before making a new setting, so that the room temper-
ature has time to stabilise.
If it is cold outdoors and the room temperature is too low, increase
the curve slope in menu 1.9.1.1 by one increment.
If it is cold outdoors and the room temperature is too high, reduce the
curve slope in menu 1.9.1.1 by one increment.
If it is warm outdoors and the room temperature is too low, increase
the value in menu 1.1.1 by one increment.
If it is warm outdoors and the room temperature is too high, reduce
the value in menu 1.1.1 by one increment.
VENTILATION
normal(50%)
ventilation1.2
speed 1 (0%)
speed 2 (40%)
speed 3 (80%)
speed 4 (100%)
Setting range: normal and speed 1-4
Default value: normal
Menu
1.2
The ventilation in the accommodation can be temporarily increased or reduced
here.
When you have selected a new speed a clock starts a count down. When the
time has counted down the ventilation speed returns to the normal setting.
33Chapter 3 | F730 – at your serviceNIBE F730