Nibe RMU S40 - RMU S40 Settings in Main Product; Caution: Refer to Main Manual; Assigning RMU S40 Address; Troubleshooting Communication Faults

HEAT
Living room
Menu 2 - "Connections"
2.
Go to the main product and select menu 7.2.1 –
"Add/remove accessories" and activate RMU S40 or
press "Search for accessories".
3.
Select an address (1 – 8) for your RMU S40.
4.
In the event of a communication fault between
RMU S40 and your main product, you are asked to
check the selected address and adjust if necessary.
RMU S40 has no
communication with your
installation. Please check the
selected address and adjust if
necessary.
Select address
5.
You can choose to control your main product accord-
ing to the moisture content (RH) in the air, which is
measured by your RMU S40. Activate this choice in
menu 7.1.6.4 – "Humidity control" in the main
product.
You can also choose to control your main product
according to the moisture content (RH) in the cool-
ing. (If you have cooling installed and activated.)
Activate this choice in menu 7.1.7.2 – "Humidity
control" in the main product. Select "Limit RH in cold"
Make your settings for RMU S40 in the main product’s
menu 1.3.3 – "Room units".
Caution
See the Installer Manual for the main product.
33NIBE RMU S40 | GB