Control – Menus
MENU – HOME SCREENS
HEATING
HEAT
Kitchen
HEAT
Living room
You make temperature settings for your installation here.
If the climate system in the house has several zones for
heating, this is indicated on the display by a function
page for each zone. You can browse between the vari-
ous zones (up to 10 can be displayed). You will see the
name and settings for each zone.
Setting the temperature (without controlling room
sensor activated):
Setting range: -10 to +10
The display shows the set values for heating (curve
offset). To raise or lower the indoor temperature, in-
crease or reduce the value on the display.
1.
Browse to the function page.
2.
Press the screen with your finger.
3.
Select the required offset.
4.
Save by pressing the green button.
The number of steps the value has to be changed in
order to achieve a one degree change to the indoor
temperature depends on the heating installation. One
step may be sufficient for underfloor heating, while radi-
ators may require three.
Setting the temperature (with controlling room
sensor activated):
Setting range: 5 – 30 °C
The value on the display appears as a temperature in °C
if the heating system is controlled by a room sensor. To
change the room temperature, increase or reduce the
value on the display.
1.
Browse to the function page.
2.
Press the screen with your finger.
3.
Select temperature:
4.
Save by pressing the green button.
Caution
A change in the room temperature can be
slowed down by the thermostats for the radiat-
ors or the underfloor heating. For this reason,
open the thermostat valves fully, except in
those rooms where a cooler temperature is
required, e.g. bedrooms.
TIP
Wait 24 hours before making a new setting,
so that the room temperature has time to sta-
bilise.
Displaying
• current indoor temperature if the indoor sensor or
wireless sensor/thermostat is connected to the relev-
ant climate system.
• required indoor temperature
• current set offset
• installed zones (Up to 10 can be displayed. Select
which zones you want to display in menu 7.)
• controlling wireless temperature sensors and/or ther-
mostats
• status if you are currently operating prioritised heating.
COOLING
You make temperature settings for your installation here.
If the climate system in the house has several zones for
cooling, this is indicated on the display by a function
page for each zone. You can browse between the vari-
ous zones (up to 10 can be displayed). You will see the
name and settings for each zone.
Setting the temperature (without controlling room
sensor activated):
Setting range: -10 to +10
The display shows the set value for cooling (curve off-
set). To increase or reduce the indoor temperature, in-
crease or reduce the value on the display.
NIBE RMU S40 | GB34
To Next Page
Loading...
