EU Declaration of Conformity (N.635/DPRO924)
and declaration of incorporation of “partly completed machinery”
Note: the contents of this declaration correspond to that stated in the official document filed in the offices of Nice S.p.A. and, in particular,
the latest version thereof available prior to the printing of this manual. The text herein has been re-edited for editorial purposes. A copy of
the original declaration can be requested from Nice S.p.A. (TV) Italy.
Revision: 0 Language: EN
Manufacturer’s name: NICE S.p.A. Product type: Control unit for 1 24Vdc motor
Address: via Callalta n.1, 31046 Oderzo (TV) Italy Model / Type: DPRO924
Person authorised to compile the technical documentation:
NICE S.p.A.
Accessories: Refer to the catalog
Address: via Callalta n.1, 31046 Oderzo (TV) Italy
The undersigned, Roberto Griffa, as Chief Executive Officer, hereby declares under his own responsibility that the product identified above
complies with the provisions of the following directives:
• Directive 2014/30/UE (EMC) EN 61000-6-2:2005 - EN 61000-6-3:2007+A1:2011
In addition, the product conforms to the following directive in accordance with the provisions applicable to “partly completed machinery”:
(Annex II, part 1, section B):
• In addition, the product conforms to the following directive in accordance with the provisions applicable to “partly completed machinery”:
Directive 2006/42/EC OF THE EUROPEAN PARLIAMENT AND COUNCIL of May 17 2006 regarding machines and amending Directive
95/16/EC (consolidated text).
- It is hereby declared that the relevant technical documentation has been compiled in accordance with Annex VII Part B of Directive
2006/42/EC and that the following essential requirements have been applied and fullled: 1.1.1- 1.1.2- 1.1.3- 1.2.1-1.2.6- 1.5.1-1.5.2-
1.5.5- 1.5.6- 1.5.7- 1.5.8- 1.5.10- 1.5.11
- The manufacturer agrees to transmit to the national authorities any pertinent information on “partly completed machinery”, in response
to a motivated request, without prejudice to its intellectual property rights.
- Should the “partly completed machinery” be commissioned in a European country with an ofcial language different to the one used in
this declaration, a translation into that language accompanying this declaration must be provided by the importer.
- The “partly completed machinery” may not be commissioned until the nal machinery into which it is to be incorporated has been decl
red to conform to the provisions of Directive 2006/42/EC, where appropriate.
The product also complies with the following standards: EN 60335-1:2012+A11:2014, EN 62233:2008, EN 60335-2-103:2015
Place and Date: Oderzo, 30/03/2018 Ing. Roberto Griffa (Chief Executive Ofcer)
To Next Page
Loading...
Need help?
General
