Nice DTX6

7 – English
English
PROCEDURE 4 - Configuring the “ON VACATION” special function
Randomly moves the time of an event by a few minutes off its programmed time; this simulates the presence of an occupant when the house is unoccupied. If the “on vaca-
tion” special function has been applied to one or more events, you must also set the maximum offset relative to the programmed actuation time of the events in question. If
the function has not be applied to any programmed event, changing this value has no effect. To set the value, proceed as follows.
Step 1 Step 2 Step 3
stop/esc
main
screen
Auto
sel
Auto
Man
Prog
ok
Prog


sel
ok
several times... (display) 2 times (display) conrm (display) 2 times ON VACATION conrm
Step 4
(2)
- end
e.g.: 35 min.
(35+ 35 =range 70min.)
ok
(display) set
(1)
conrm (display)
NOTES:
(1) - The value can be set from 00
(*)
to 75 minutes, in 5 minute steps. For example, if you set a value of 15 minutes and the event is programmed to start at 8.00, the system
will actuate the event at any time between 7.45 (15 minutes before 8:00) and 8.15 (15 minutes after 8:00). The system will therefore start the event at any time in this
30 minute range.
(*) - Setting a value of 00 disables the function.
(2) - After Step 4, to return to the main screen, repeatedly press n/esc until Auto starts flashing.