13 - English
EN
is authorised to enable the automation.
The two-way transmitter, after the sending of a command, becomes itself a “receiver” of information coming
from the associated receiver.
With the memorisation of two-way transmitters in the OXIBD (OXIBD/A) receiver, the identication code of the
same receiver is automatically memorised by the transmitter. Warning! - if the two-way transmitter in the OXIBD
(OXIBD/A) receiver is deleted, to complete the operation it is necessary to also delete the transmitter’s memory.
To perform this procedure, consult the transmitter’s instruction manual.
PROCEDURE 5 - FULL or PARTIAL deletion of the receiver’s memory
01.
On the receiver: hold down key A and observe the status of
the green LED B: after 6 seconds it will light up then switch
off. After a few seconds it will start flashing; then immediately
choose the type of desired deletion:
> to delete ALL the transmitters: release key A exactly at the
3
rd
flash
> to delete ALL THE RECEIVER’S MEMORY: release key A
exactly at the 5
th
flash
> to delete (in the receiver) the control unit’s Series/Ad-
dress, for the BusT4 network: release key A exactly at the 7
th
flash
This function can be performed also using the O-Box / O-View programmers.
To Next Page
Loading...
Need help?
General
