Nice OXIBD

EN
English - 14
3.7 - Deleting a SINGLE transmitter or a SINGLE key from the receiver memory
PROCEDURE 6 - Deleting a SINGLE transmitter or a SINGLE key from the receiver memory
01. On the receiver: hold down key A, observe the green
LED B light up and move to step 02 when it switches
off.
1
2
02. On the transmitter to be deleted:
• If the transmitter is a one-way device:
(on the transmitter) hold down the key (*4) to be de-
leted and release it after LED B (on the receiver) has
emitted the 1
st
of 5 quick green flashes (= deletion
completed correctly).
• If the transmitter is a two-way device:
(on the transmitter) press and release the key to be
deleted (*4): LED B (on the receiver) will emit 5 quick
green flashes (= deletion completed correctly).
(*4) Note - If the transmitter is memorised in “Mode 1”, any key can be pressed. If the transmitter is memo-
rised in “Mode 2”, the entire procedure must be repeated for each memorised key that must be deleted.
This operation can also be performed through the O-Box / O-View programmers.
3.8 - Locking (or release) of memorisations carried out with the “near the control unit” procedure
and/or through the “enabling code”
This function prevents the memorisation of new transmitters in the receiver, when using the “near the receiver”