8
5.5 - Titan actuator wiring
Terminal Block
For Harness
Connections
With the release handle up, remove the screws from the limit cover and remove the cover. On the bottom of the actuator
loosen the strain relief nut and insert the wire into the actuator housing. The connections are on the top of the atuator behind
the limit assembly.
Using the supplied key, unlock the manual release handle. Lift upwards on the release handle as shown.
FIGURE 5 - 8 MANUAL RELEASE HANDLE
FIGURE 5 - 9 WIRE HARNESS INSERTION
THE FOLLOWING SECTION NEED ONLY BE USED FOR REWIRNG IN THE EVENT OF A
DESIRED LONGER OR SHORTER CABLE LENGTH.
To Next Page
Loading...
