Summary
Preface P. 6
Chapter 2 P. 17
Technical data
Chapter 5 P. 76
Reception, storage
and installation
Chapter 4 P. 54
General information
Chapter 3 P. 47
Application notes
Chapter 6 P. 115
Options
Chapter 7 P. 129
Preventive maintenance
Chapter 1 P. 15
Overview
and installation diagram
Answer Drives 1000
70
4
4.7.5 FIRE
The plastic materials used (e.g. conduits, electrical cables) are
self-extinguishing and comply with the regulations in force.
The AD1000, having to be incorporated/integrated in a machine/system/
installation/assembly, is not supplied with its own fire-fighting system.
• The user must assess the need for an appropriate fire extinguishing
system in the site/establishment and/or premises in which the AD1000
is incorporated/installed, in compliance with safety and fire prevention
regulations in force in the country where the unit is used and internal
factory regulations. Do not use open flames or smoke near the AD1000.
DANGER
In case of fire always immediately switch off the main switch of the main
power supply line.
CAUTION
The end user is clearly responsible to install and evaluate the most
appropriate fire protection system and in general in accordance with
the country where the unit is used, of regulations in force and site/factory
conditions.
4.7.6 EXPLOSIVE ATMOSPHERE
The AD1000 is not suitable for working in explosive or classified
environments. The AD1000 therefore is not suitable for use in areas:
• explosive or partly explosive;
• classified;
• where there are corrosive atmospheres;
• where there are high concentrations of dust;
• in which there are high concentrations of oily suspension;
• with risk of fire resulting from any ignition materials or source.
It is strictly prohibited to use the unit in all areas listed above or in any case
in environments other than those included in this chapter.
4.7.7 BLINDING
Risk present, mainly, in cleaning and maintenance phases and in case of
accidental contact with the product in the case of cleaning for removing
dust or dirt that has accumulated.
When the AD1000 is cleaned with compressed air, the personnel involved
must always wear proper eye protection.
CAUTION
It is mandatory to wear eye protection.
Use goggles to protect the eyes and face even in the case of any electrical/
mechanical maintenance task on the AD1000.
4.7.8 FALL AND/OR EJECTION OF OBJECTS
• Do not leave, even temporarily, work tools and objects along and above
the AD1000 to prevent their fall or ejection.
• Before opening any door closed with coded keys, removing panels
or access to any part of the AD1000, remove and disconnect all the
power supplies to the AD1000 (medium and low voltage side) using
the operating parts provided for this purpose by the system installer/
integrator.
4.7.5 FIRE - 4.7.6 - 4.7.7 - 4.7.8
To Next Page
Loading...
