EasyManuals Logo

Nidec Unidrive M400 series User Manual

Nidec Unidrive M400 series
70 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
12 Unidrive M400 Quick Start Guide
Issue Number: 8
Table 3-1 Tools required
Table 3-2 Recommended torque settings
Table 3-3 Tightening torque for mounting feet
* A minimum clearance of 50 mm (1.97 in) above and below Frame 01 to 04 products is
permissible in applications where either the ambient operating temperature is 35 °C
(95 °F) or less or the average output current is derated by 20 %.
Derating for reduced clearances is to be applied in addition to the derating for increased
switching frequency if operating above 3 kHz. Refer to the Power Installation Guide for the
current derating due to an increase in switching frequency.
If Din rail mounting is used in an installation, then mounting screws should be used to
secure the drive to the back plate.
Tool Location Size 1 Size 2 Size 3 Size 4
Small terminal screwdriver Control, relay and STO terminals

3 mm Flat-bladed screwdriver Power terminals
5 mm Flat-bladed screwdriver Terminal cover

4 mm Flat-bladed screwdriver AC power terminals
Philips screwdriver Power terminals

Torx 10 driver EMC & MOV screws

Torx 15 driver Fan screw
Torx 20 driver Fan screw

Model size
Terminal block
description
Torque settings
All
Control terminals 0.2 N m (0.15 Ib ft)
Relay terminals 0.5 N m (0.37 Ib ft)
Ground terminals 1.5 N m (1.10 Ib ft)
1
Power terminals
0.5 N m (0.37 Ib ft)
2, 3, 4 1.4 N m (1.03 Ib ft)
Drive size Tightening torque
1 to 3 1.3 N m (1 lb ft) to 1.6 N m (1.2 lb ft)
4 2.5 N m (1.8 lb ft) to 2.8 N m (2.1 lb ft)
NOTE
NOTE
NOTE

Other manuals for Nidec Unidrive M400 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nidec Unidrive M400 series and is the answer not in the manual?

Nidec Unidrive M400 series Specifications

General IconGeneral
BrandNidec
ModelUnidrive M400 series
CategoryController
LanguageEnglish

Related product manuals