MRT10*RDA001A/E
Page
Table of Contents
§
1 INTRODUCTION ........................................................................................................ 1-1
§
2 SAFETY PRECAUTIONS ............................................................................................ 2-1
§
3 TROUBLE SHOOTING............................................................................................... 3-1
§
4 SUB TOUBLE SHOOTING ......................................................................................... 4-1
4.1 Initialization screen does not appear on the CB display. ...............................................4-1
4.1.1 Backlight of the LCD module does not light up...................................................4-2
4.2 Initialization is not completed properly. ........................................................................4-3
4.2.1 The battery AS does not move to the right and left. ............................................4-4
4.2.2 The R disk AS does not turn..............................................................................4-5
4.2.3 The L disk AS does not turn. .............................................................................4-7
4.2.4 The PD and convergence of the MB is not initialized properly. ............................4-9
4.2.5 The right disk of the MB is not initialized properly.............................................4-10
4.2.6 The left disk of the MB is not initialized properly............................................... 4-11
4.3 An error message appears. .......................................................................................4-12
4.3.1 “Error 01: Communication Error CB-MB” appears..........................................4-13
4.3.2 “Error 11: Communication Error CB-RB” appears. ..........................................4-14
4.3.3 “No appointment data!!” appears. ...................................................................4-14
4.3.4 “Chart doesn’t work.” appears. .......................................................................4-15
4.3.5 “Setup data is initialized.” appears....................................................................4-16
4.3.6 “CF card -- Read Error!!” appears. ................................................................4-16
4.3.7 “CF card -- Write Error!!” appears. ................................................................4-16
4.3.8 “CF card -- File Error!!” appears. ...................................................................4-16
4.3.9 “CF card -- File not found!!” appears..............................................................4-16
4.3.10 “CF card -- Card not found!!” appears. ........................................................4-16
4.3.11 “No data!!” appears. .....................................................................................4-16
4.4 The instrument cannot be operated with the control box.............................................4-17
4.4.1 The instrument cannot be operated with the switches. .......................................4-17
4.4.2 The instrument cannot be operated by turning the dial. ......................................4-18
4.4.3 The instrument cannot be operated with the touch-screen panel. .......................4-18
4.5 The compact flash memory card cannot be used........................................................4-19
4.6 The IC card cannot be used......................................................................................4-19
4.7 The printer does not print..........................................................................................4-20
4.8 The communication with the auto refractometers or lensmeter cannot be done. ...........4-21
4.9 The chart projector does not work as specified with the control box. .........................4-22
To Next Page
Need help?
General
