Nikon D700 - Confirm Data; Initial Settings (Factory Default Settings); Version No.; Serial no

VBA22001-R.3754.A
-A137 ･ D700-
It is necessary to calculate the reference values in order to prevent the color temperature uctuation caused by
the shutter tester or color viewer's changes over time from affecting the results of the shooting image adjustment.
By using the reference body, calculate the reference values once in about every 3 months, when either of the
uorescent of the color viewer or tool lens (F5.6) or ND lter (ND8X2) is replaced.
(13) Initial settings (Factory default settings)
This restores factory default settings. Select the language and video mode. Because this setting of RP DG-PCB
is blank, be sure to set the initial default setting when the DG-PCB is replaced.
(14) Conrm data
Saving/restoring of the system xed values, image register, TFT register, EEPROM1, 2, 3.
The functions of saving/restoring each data is for sending backup data to Service Planning for analysis, if some
problem occurs.
Image data storage space is divided into FLASH ROM system area (system xed value, image register, and
TFT register) and EEPROM system area (EEPROM 1, EEPROM 2, and EEPROM 3). But the data itself is
related with each other in a complicated way, so in case of saving/restoring data, be sure to back up all the data
as a set without fail.
(15)
Version No./ Serial No.
RISC rmware version and serial number are indicated. Serial number can be written.
※ Whenever the license sheet is replaced, be sure to input the serial number.
Changed page △× 3
The System xed data
The Image register
TFT register
EEPROM 1
EEPROM 2
EEPROM 3
FLASH ROM system area
EEPROM system area
△（Addition） △（Addition）
△（Addition）
August, 19,2008
INC