Nikon Df - Page 114

94
r
2 Set white balance to L (Preset manual).
Press the L (U) button and rotate the main command dial
until L is displayed in the monitor.
3 Select a preset.
Press the L (U) button and rotate the sub-command dial
until the desired white balance preset (d-1 to d-4) is displayed
in the monitor.
4 Select direct measurement mode.
Release the L (U) button briefly and
then press the button until the L icon
in the monitor starts to flash.
Aspot
white balance target (r) will be
displayed at the selected focus point.
L (U) button Main command dial Monitor
L (U) button Sub-command dial Monitor
Monitor