3-5
3
Input Point Name/Numbe
3-2 Pre-Start
Input Point Name/Number
You can use point numbers or names up to 12 digits in length. When the
system gives you a default PT, basically, the Last recorded PT + 1 is used,
except the case where the last digit is alphabet.
For coordinate records, you cannot use a point name/number that already
exists in the current Job except when you record sideshots or stakeout shots.
(See p.8-2)
1) Pressing [ENT] without a PT
In COGO, a coordinate input screen will
be displayed if you leave the PT field
blank. This coordinate will be used
temporarily in the calculation and will not
be saved in the database.
When you search a point in Stakeout or Data View/Edit without PT, the
system searches the point based on the input CD or other given
conditions. Otherwise, you must enter a PT to record the point.
Ｉｎｐｕｔ １ｓｔ Ｐｏｉｎｔ
ＰＴ：
■
ＨＴ： １．５０００ｍ
ＣＤ：
･The cursor is placed on the first
character of the string when the input
mode is activated. It is “All Replace”
mode.
･Pressing the right arrow key changes the input mode into
“Overwrite”, leaving the cursor on the first character.
Pressing the left arrow key moves the cursor to the end of the current
input.
Ｉｎｐｕｔ １ｓｔ Ｐｏｉｎｔ
ＰＴ：１２０５
ＨＴ： １．５０００ｍ
ＣＤ：
To Next Page
Loading...
Need help?
General
