Chapter 2 Individual Operations
53
Chap. 2
Individual Operations
(4) Set the setting mode switch to the left side to operation
mode.
Nosepiece address buttons 1 to 6 light for a few seconds to
indicate that setup is complete.
MEMORY
Setup via DS-L4 Microscope Camera Control
Unit or a PC
The toggle pattern can also be configured via DS-L4
Microscope Camera Control Unit or Ni Setup Tool. See the
respective instruction manual for the details of settings with
DS-L4 and Ni Setup Tool.
Operation when using the toggle function
To use the toggle function, press the toggle pattern switch to
select “toggle pattern 1” or “toggle pattern 2.”
To switch between the two objectives, press the nosepiece
forward/reverse rotation buttons (the two buttons are not
differentiated when using the toggle function).
OFF
TOGGLE
PATTERN
MEMORY
12
Nosepiece address buttons
Pressing a nosepiece address button when using the
toggle function allows you to bring a desired address to the
optical path.
To stop using the toggle function, press the toggle pattern switch
until the toggle function is turned OFF.
Nosepiece Operation
Operation
Toggle
pattern switching
Microscope main body Remote control pad
Nosepiece forward
rotation button
Nosepiece reverse rotation
button
Nosepiece address
buttons
Toggle function OFF
Nosepiece forward rotation
(incrementing the address)
Nosepiece reverse rotation
(decrementing the address)
Rotate to the specified
address
Toggle pattern 1
Switching between two addresses
configured in the toggle pattern 1.
Toggle pattern 2
Switching between two addresses
configured in the toggle pattern 2.
Nosepiece
address
buttons
Toggle pattern switch
Toggle function OFF
Toggle pattern 1
Toggle pattern 2
Toggle address LED
LEDs for the addresses set for
the toggle pattern light up.
To Next Page
Loading...
