Nikon Eclipse Series User Manual

1
Components of the System
1
If the system has not yet been assembled, see Chapter 3 “Assembly” first.
For details on assembling and handling the microscope, see the instruction manual supplied with the microscope.
This attachment can be mounted on the ECLIPSE Ni-E, Ni-U, Ci-E, Ci-S, Ci-L, 90i, 80i, 50i, E600W, E600 or E400
microscope.
Note that the illustrations in this manual shows the ECLIPSE Ci-S microscope for convenience.
Depending on the type of set you have purchased, some of the following components may not be included.
Dual-viewing (face-to-face)
This model allows the main observer and the secondary observer to be positioned face-to-face during observation.
Dual-viewing (side-by-side)
This model allows the main observer and the secondary observer to be positioned side-by-side during observation.
When a pointer is going be used, assemble the system so that the secondary observer will be positioned on the right. If
reversed, the pointer control section will be at the rear of the microscope.
Eyepieces for secondary observer
Eyepiece tube for secondary observer
Teaching head F-F
Microscope
A
C adapte
r
Pointe
r
Eyepieces for
secondary observer
Eyepiece tube for
secondary observer
Teaching head S-S
Microscope
AC adapte
r
Pointe
r
Support stand
(Mounting ring)
(Height adjustment clamp screw)
Heat protection shield
(provided with the teaching head F-F)

Nikon Eclipse Series Specifications

General

Objectives	Plan Achromat, Plan Fluor, Plan Apochromat
Objective Lenses	4x, 10x, 20x, 40x, 100x
Magnification Range	40x to 1000x
Eyepiece	10x
Illumination	LED, Halogen
Observation Methods	Brightfield, Darkfield, Phase Contrast, Fluorescence
Focusing	Coarse and fine focusing
Stage	Mechanical stage
Condenser	Abbe condenser
Interpupillary Distance Adjustment	48-75mm
Diopter Adjustment	Typically +/- 5 diopters
Power Supply	100-240V AC
Nosepiece	Revolving nosepiece, typically with 5-7 objective positions