129
Cleaning the Scanner
Before cleaning the scanner, turn it off and unplug the power cord. The front of the scanner is
made of plastic, and consequently cannot be cleaned with volatile cleaners such as alcohol or
paint thinner. Use a blower to blow off dust or wipe the surface with a dry cloth. Remove dirt
from the metal rear panel of the scanner using a soft, dry cloth. If this is not sufficient to
remove all dirt, clean with a cloth that has been slightly dampened with a neutral detergent or
liquid soap.
Transporting the Scanner
Follow the steps below to prepare the scanner for transport.
1
Turn the scanner on and remove any holders.
2
Close the sliding cover.
3
Wait for the status LED on the front of the scanner to stop blinking.
4
Turn the scanner off.
5
Disconnect the power and interface cables.
6
Package the scanner in the original packing materials.
Cautions
Nikon scanners are certified for use in the country or region of sale. Transportation and use out-
side the country or region of sale are at the user’s own risk and responsibility.
Where the original packing materials are not available, package the scanner carefully in materi-
als at least as shock resistant as the originals.
To Next Page
Loading...
