FORM NO. 56091105 - BU800 - 5
revised 6/2016
INTRODUCTION
This manual will help you get the most from your Nilfi sk burnisher fl oor
machine. Read it thoroughly before operating the machine.
This battery powered walk-behind burnisher with a 1500 rpm pad speed
is used for restoring and maintaining a high gloss shine on smooth and
solid fl oors. Features include on-board battery charger also passive
and (optional) active dust control.
This product is intended for commercial use only.
PARTS AND SERVICE
Repairs, when required, should be performed by your Authorized
Nilfi sk Service Center, who employs factory trained service personnel,
and maintains an inventory of Nilfi sk original replacement parts and
accessories.
MODIFICATIONS
Modifi cations and additions to the cleaning machine which affect
capacity and safe operation shall not be performed by the customer
or user without prior written approval from Nilfi sk A/S. Unapproved
modifi cations will void the machine warranty and make the customer
liable for any resulting accidents.
NAME PLATE
The Model Number and Serial Number of your machine are shown
on the Nameplate on the bottom of the machine. This information is
needed when ordering repair parts for the machine. Use the space
below to note the Model Number and Serial Number of your machine
for future reference.
MODEL NUMBER
SERIAL NUMBER
UNCRATE THE MACHINE
When the machine is delivered, carefully inspect the shipping carton
and the machine for damage. If damage is evident, save the shipping
carton so that it can be inspected. Contact the Nilfi sk Customer Service
Department immediately to fi le a freight damage claim (phone number
is provided on the back cover of this manual).
PREPARING THE MACHINE
FOR USE
WARNING!
Use extreme caution when working with batteries. Sul-
furic acid in batteries can cause severe injury if allowed
to contact the skin or eyes. Explosive hydrogen gas is
vented from inside the batteries through openings in
the battery caps. This gas can be ignited by any arc,
spark or Á ame.
WHEN SERVICING BATTERIES....
• Remove all jewelry
• Do not smoke
• Wear safety glasses
• Work in a well-ventilated area
• Do not allow tools to touch more than one battery terminal
at a time.
CAUTION!
Electrical components in this machine can be severely
damaged if the batteries are not installed and connected
properly. Batteries should be installed by your local
NilÀ sk dealer or by a qualiÀ ed electricain.
The BU800 may be used with three 12 volt 200 amp hour bat-
teries or three 12 volt 234 amp hour AGM batteries.
CAUTION!
The battery charger must be reprogrammed when
switching from lead acid to AGM batteries. See the
Charger Manual for instructions.
EN
ENGLISH
To Next Page
Loading...
Need help?
General
