EasyManuals Logo

Nilfisk-Advance BU800 51BT User Manual

Nilfisk-Advance BU800 51BT
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
8 - FORM NO. 56091105 - BU800
EN
ENGLISH
MAINTENANCE
A
AFTER USE
After working, before leaving the machine:
1 Store the machine in a clean and dry place, indoors only.
2 Park the machine on a level oor. Ensure once the machine is
left unattended it is secured against unintentional movement.
3 Turn the Key Switch (1) to the OFF position (O).
4 Remove the key from the machine to prevent unauthorized use
of the machine.
5 Perform the daily maintenance procedures (see the Mainte-
nance schedule).
MAINTENANCE SCHEDULE
Maintenance Item Daily Monthly Yearly
Charge Batteries x
Check/Replace Dust Bags x
Check/Replace Skirt x
Clean Pad x
Lubrication x
Check/Service Pad Motor Brushes x
Service Drive Motor Brushes x
BATTERY MAINTENANCE
Charge the batteries each time the machine is used for 1 hour or
longer, or whenever the Battery Meter reads in the red area.
To Charge the Batteries...
1 Remove cover.
2 Plug charger in.
3 Check the uid level in all battery cells after charging the batteries.
Add distilled water, if necessary, to bring the uid level up to the
bottom of the ller tubes.
CAUTION!
To avoid damage to oor surfaces, wipe water and acid
from the top of the batteries after charging.
CAUTION!
Acid can spill onto the oor if the batteries are over-
lled.
IMPORTANT
Motor damage resulting from failure to service carbon brushes is not
covered under warranty. See the Limited Warranty statement.
SPECIFICATIONS
Model BU800 51BT
Model Number 56383526
Power Supply 36 volt
Motor, Pad 1.5 kW (2.0 hp) 55 amp
Motor Traction .37 kW (.5 hp) PM
Drive System Direct Drive
Pad 51cm (20”)
Pad Speed 1500 rpm
Pad Pressure Automatic
Speed, Forward 0 - 73 m/min (0-240 ft/min)
Speed, Reverse 0 - 52 m/min (0-170 ft/min)
Vibration <7.6 mm/s
Sound Level (dbA) 68
Drive Wheel 4cmx20cm (1.62”x8.00”)
On-board Charger Standard 36V, 21A
-AC Input 100-240V ~ 50/60Hz 12-6A
Length 127cm (50 inches)
Width 58cm (23 inches)
Height 105cm (41.25 inches)
Burnishing Swath 51cm (20 inch)
Polishing Rate 2230 sq. m/hr. (24,000 sq. ft/hr)
Weight (w/o batteries) 79 kg / 174 lbs.
Gross Vehical Weight (GVW) 233 kg / 515 lbs.
Gradeability - Cleaning (max.) 2%

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-Advance BU800 51BT and is the answer not in the manual?

Nilfisk-Advance BU800 51BT Specifications

General IconGeneral
BrandNilfisk-Advance
ModelBU800 51BT
CategoryFloor Machine
LanguageEnglish

Related product manuals